Waterous AQUIS 1.5, Installation, Operation And Maintenance Instructions

Page: 40 / 64

40
|
64
Safety Introduction Product Overview Installation Operation Maintenance Troubleshooting
2. Install the inlet side of the manifold towards the water pump.
Important:
Installing the foam manifold at more than a ± 15° tilt may
cause inaccurate readings
(Figure 30)
.
Top
Figure 30
3. Connect the 3 meter, M12, 4-pin extension cable to the cable attached to
the flowmeter.
Note: The sensor is calibrated at the factory and secured into place.
Do not rotate the 90° connector attached to the sensor. Doing so
causes inaccurate readings.
Note:
Do not force the plug into the connector, you will damage it.
4. Route the cable to the control box.
5. 3 meter, M12, 4-pin extension cable Connect the cable to the control box.
Refer to:
"Connecting M12 Cables to the Control Box" on page 38
.
Installing the Flowmeter Tee
1. Orient the flowmeter with the connector at the top (Figure 32) .
2-1/2-inch tee shown
Figure 31
2. Install the flowmeter tee into the waterway.
Note: The flowmeter tee can be installed before or after the waterway
check valve.
3. Connect the 3 meter, M12, 4-pin extension cable to the cable attached to
the flowmeter.
Note:
The sensor is calibrated at the factory and secured into place.
Do not rotate the 90° connector attached to the sensor. Doing so
cause inaccurate readings.
Note: Do not force the plug into the connector, you will damage it.
4. Route the cable to the control box.