Plumbing Installation - ST2 Tap
1.
A hole with a diameter between 32 mm and 35 mm is required for the ST2 tap.
Select a suitable position on the counter top that is more than 50 mm away
from the wall, and for the tap to dispense into the sink bowl with ample
clearance below the outlet.
2.
Referring to the diagram below, insert hot and ambient inlet water pipes into
the corresponding holes, then twist the pipes to fix them into the tap body.
Figure 13:
ST2 Tap Plumbing (view 1)
Copyright Sodatap© 2023 Page 20 STM1 Manual V10
