4. Critical, the pan must be on a level surface square to the wall, if the floor slopes away the pan
will need to levelled using suitable floor chocks around the pan to support and stabilise the pan.
Toilet cistern installation
1. Marking Cistern wall fixing holes- place cistern onto Pan without sponge gasket, square up cistern
to pan and mark wall through cistern fixing holes, remove cistern and drill wall and fit wall plugs
based on wall material.
2. Locate the cistern on to the pan with the sponge gasket placed on the cistern outlet valve tail
and connect the tank to pan using attachment bolts. Ensure that the cistern and pan are china to
china contact when tightened DO NOT OVER TIGHTEN.
3. Screw cistern to wall using suitable screws and preassembled wall plugs.
4. Connect one end of the supplied Female to female Flex connector to the inlet valve (DO NOT
OVERTIGHTEN), connect the other end to mains Water. (DO NOT OVER TIGHTEN).
5. Place cistern lid on top of the cistern and check push button workability.
6. Assemble the seat using the seat assembly instructions supplied in the seat box
Important
: Sand and debris move through water pipes. Always flush the line prior to
connecting Toilet Suite inlet pipe to water control valve.
Warranty Contact Details:
Tradelink Pty Ltd
ABN: 29000003832
1051 Nudgee Rd
Banyo QLD 4014
Ph: 1300 658 277
[email protected]
Warranty:
For continued piece of mind, this product comes with limited warranty from date of purchase.
For full warranty terms and conditions of the warranty including how to claim and your rights as a
consumer, please consult www.raymor.com.au .
“
If you are a consumer as defined under the Australian Consumer Law, our goods come with
guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a
replacement or refund for a major failure and compensation for any other reasonably foreseeable
loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be
of acceptable quality and the failure does not amount to a major failure.
”
Issue Date: 10 Oct 2020
Revision Number: 1.0
Revision Date: N/A
