![background image](http://html1.mh-extra.com/html/waterlogic/wl270/wl270_operating-installation-and-service-manual_3652694010.webp)
PRE-INSTALLATION PROCEDURES
DANGER!
ELECTRICAL SHOCK HAZARD.
Only qualified personnel who have read and understand this entire manual should attempt to
install, or service this unit, failure to do so could result in death or serious injury. DO NOT plug
into an electrical supply until specifically instructed.
WARNING!
ALWAYS SANITIZE BEFORE USE.
Sanitize before use to eliminate any potential microbiological contaminates.
Washing of the Internal Plastic Reservoir, Lid and Float
Materials Needed:
•
Personal Protective Equipment. Rubber or Nitrile Safety Gloves and Protective Eyewear
•
Phillips Screwdriver
•
Sanitizer - Household Bleach (5.25% Sodium Hypochlorite) or Citric Acid Based Cleaner
•
Unused sponges or paper towels
•
Dish Soap
•
Clean water
1.
Unpack the
Waterlogic WL270
and check exterior for damage.
CAUTION!
ALWAYS WASH THE INTERNAL PLASTIC RESERVOIR, LID AND FLOATS PRIOR TO
INSTALLATION.
The internal wetted surfaces of the machine have been handled multiple times in the process of
manufacturing. By following the steps below, you will ensure the cleanliness and sterility of the
drinking water. Refer to the flow diagram in this manual prior to washing of the plastic reservoir,
lid and floats.
2.
Remove the top cover and lower panel of the
WL270
. The two screws securing the top cover are
located in each rear corner. The two screws securing the lower front panel are located on the
front, lower sides near the floor. Depress the recessed tabs of the lower front panel (under the
front-end of the machine) and pull outward simultaneously to remove.
WL270
Operating, Installation, and Service Manual Page 10 - Revision: 4-7-2015