WaterLogic WL200 Troubleshooting Download

Page: 1 / 2

WL200 Manual

Page 39 - Revision: 4-29-2019

POWER TROUBLESHOOTING INDEX

1. Red Power Switch is lit but the red LED on the Front is not lit

2. Compressor Runs but does Not Chill

3. Compressor is Not Running

Red Power Switch is lit but the Red LED on the Front is not lit

Possible Reason

Solution

Bad Transformer

Replace Transformer

Black Power Connector to the

PCB is not properly connected Properly connect.

Bad Front PCB

Replace Main PCB

Part Number: EN-6086 / Waterlogic P/N 12-8615.

Defective Red Power /

Compressor Switch

Replace Red Power / Compressor Switch

Compressor Runs But Does Not Chill

Possible Reason

Solution

Condenser is dirty

Clean the condensing coil of any obstructions or dust.

Reduction of airflow into unit. Make sure unit is not under minimum ventilation requirements (2

to 4 inches).

Compressor is running very

hot.

Low or lost refrigerant. Refrigerant recharge required.

Summary of Contents for WL200

Page 1: ...Connector to the PCB is not properly connected Properly connect Bad Front PCB Replace Main PCB Part Number EN 6086 Waterlogic P N 12 8615 Defective Red Power Compressor Switch Replace Red Power Compre...

Page 2: ...ower and Compressor Switch on I ON Compressor Starting Circuit Turn Red Power and Compressor Switch off O OFF Remove the compressor cap on side of the compressor Disconnect the black and red terminal...