Analysis Chart
Important:
Please record all information
for three consecutive days at 12h00
Day 1
Day 2
Day 3
Outside air temperature .................................................................
Weather conditions outside (eg: cloudy, sunny or rainy) ................
Pool water temperature ......................................**Use a pool
thermometer
Pool water temperature ..................................... **use the reading
from the electronic control on the pool heat pump
Important:
Please record all information
for three consecutive days at 20h00
Day 1
Day 2
Day 3
Outside air temperature .................................................................
Weather conditions outside (eg: cloudy, sunny or rainy) ................
Pool water temperature ......................................**Use a pool
thermometer
Pool water temperature ..................................... **use the reading
from the electronic control on the pool heat pump
Circuit breaker trips
If you have purchased a remote control (or other equipment), make sure this equipment
was properly installed. If the problem originates from the installation of this equipment,
Waterco’s warranty will not apply and you will have to pay the cost of the service call.
1. The amperage of the circuit breaker AND the electrical wiring must be as the instructions
on the pool heat pump name plate, otherwise notify your installer or electrician to
correct this problem, as this is not covered under the warranty.
2. If the circuit breaker and electrical wiring are as stated, make sure the drains, located
on each side of the base of the pool heat pump are not obstructed.
IMPORTANT
