Cell Housing dimensions
GENERAL SAFETY RULES
1) The equipment mentioned in this manual is specially designed for the sanitizing of
water in swimming pools.
2) It is designed to work with clean water at a temperature not exceeding 35°C (95°F).
3) The installation should be carried out in accordance to the safety instructions of
swimming pools especially Standard HD 384.7.702 and the specific instructions for
each facility.
4) The rules enforced on accident prevention should be carefully followed.
5) Any modification of the chlorinator requires the prior consent of the manufacturer.
Original replacement parts and accessories authorized by the manufacturer ensure a
high level of safety. The manufacturer accepts no liability for the damage and injuries
caused by unauthorized replacement parts and accessories.
6) During operation, some parts of the chlorinator are subject to dangerous electric
voltage. Work may only be performed on the chlorinator or on the equipment
connected to it after disconnecting them and the starting device from the mains power.
7) The user should make sure that assembly and maintenance tasks are carried out
by qualified authorized persons and that these persons have first carefully read the
Service and Installation Instructions.
8) The operating safety of the chlorinator is only guaranteed if the Installation and Service
instructions are correctly followed.
9) The limit values stated in the Technical Specifications should not be exceeded under
any circumstance.
10) In the event of defective operation or fault, contact the manufacturer’s Technical
Support Department or its nearest Authorized Agent.
11) If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person.
12) This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
13) The appliance is not intended for use by young children. Young children should be
supervised to ensure that they do not play with the appliance.
These chlorinators are approved and conformed to AS3136 Swimming Pool Equipment, as
a prescribed article under Australian Registration.
These chlorinators conform to the Australian Electromagnetic Compatibility Standard
marked by the C-tick.
WARRANTY
Two Years Warranty:
Hydrochlor
MK3
2 years*
Electrolytic Salt Cell
2 years
Power pack
2 years
Commercial Installations
1 year
*Please refer to Waterco’s Warranty terms and conditions
TECHNICAL SPECIFICATIONS
Power Unit Waterco Salt Cell
Input
220-240V AC
Frequency
50/60 Hz
Current
1.6 A
Socket Outlet
220-240V AC
Maximum Current Output
8A
Minimum Salt Level
4000 TDS
Maximum Salt Level
6000 TDS
Type of Salt
Standard Pool Salt/
Mineral Salt
Input
20V DC
Maximum Current Output
6A DC
Waterco Salt Cell
Chlorine Production
(g/hr)
Max Pool Size/ Climate
Temperate
Tropical
Series 2000
20
60,000
48,000
Series 2500
25
80,000
60,000
Series 3000
30
100,000
72,000
Recommended Pool Sizes
SYMPTOM
POSSIBLE CAUSE
REMEDY
Not keeping time
Time clock setting, power
outage
Make sure battery have been
charged for a least 70hrs to achieve
max capacity
Electrical fault
Return to distributor for repair
All LEDs blinking
Electrical fault
Return to distributor for repair
No chlorine production
Control unit set to pump only
Press Chlorine Production button to
set the desired level
Time Switch in OFF position
Set Time Switch to ON or AUTO
position
Pump not working
Pump not connected to pump
socket outlet
Plug pump lead to Pump Socket
outlet
No flow detected
Check pool water level
Check position of multiport valve
Check connection of flow sensor pin
I pg 09
Waterco Hydrochlor
MK3
A (mm)
B (mm)
C (mm)
D (mm)
370.0
136.5
280.0
188.8
