WaterClinic LOTUS-72, User Manual

Page: 16 / 56

ENG 14
• RO Membrane Installation:
First take the water purifier out of its package. Open the water purifier’s
outer cover. Unscrew the membrane shell cover inlet water connection
and take out the inlet water pipe. Then use the membrane shell wrench
to unscrew the membrane shell cover. Take the RO membrane out from
its package. Place the end of the membrane with the O-ring into the reverse osmosis membrane shell (See Diagram 11) and push it in.
Finally, screw the membrane shell cover back on and use the membrane
shell wrench to tighten the membrane shell cover. Connect the inlet water
pipe into the inlet water connector on the membrane shell and screw in
the nut. Place the membrane shell card into the large single clip available
and attach the water purifier cover back on.
Diagram 14
Diagram 15
Pure Water
O-ring
Membrane Shell
RO Membrane
Waste Water
Sealing Ring
Inlet Water
Membrane
Shell Cover
• Membrane Installation Warnings:
• The package of the reverse osmosis membrane contains a small amount
of protective solution in order to prevent microbiological contamination
of membrane components during storage and transportation.
• You should pay attention to the direction of the RO membrane during
installation.
• When installing the RO membrane; you should first make sure that one
end of the membrane has an O-ring;
• During installation, be sure to put the end with the O-ring into the end
of the membrane shell with the pure water connection. If you install
the reverse osmosis membrane correctly, you will only need a little force
to mount it into the membrane shell. If you encounter too much
resistance, please do not force the reverse osmosis membrane into
the membrane shell. Doing so may cause permanent damage to the
membrane shell or membrane components (the membrane
manufacturer does not assume responsibility for returned components
due to damages incurred during installation).
• Damage to the membrane shell and reverse osmosis membrane
components inflicted as a result of the abovementioned reasons is not
covered under the water purifier’s warranty.
• Do not cut or try to disassemble the replaced membrane. RO membrane
can filter microorganisms and cutting or harming RO membrane may risk
on you and your environments health.
• Installation of the Pre-Filters:
First take the pre-filters out of their packages. Tear off the packaging
of the filters in the order they should be installed: first is the 5 micron PP
filter; second is the granular activated carbon filter, note that the rubber
pad must be installed on the top of the activated carbon filter; third is
the 10" block carbon (See Diagram 15).