12
13
Tub hole
14
15
16
528/538 CAbLe ASSeMbLy InSTRuCTIOnS
This product comes completely assembled except the tee so the installer can visually identify how the component goes together.
© 2009 WATCO Mfg. Co.
Designs and dimensions of product are subject to change without notice.
Form: Cable-Inst. Rev. 6/09
6
3
Tub hole
11
(2.) DraIn Ell assEmbly
1. Remove Item 3 (Cable Drain Ell Locking Pin)
by unscrewing.
2. Place Item 6 (Drain Ell) with Item 5 (Drain Ell
Washer) under tub hole.
3. Place Item 4 (Cable Strainer Body) into the
tub hole.
4. Screw Item 3 (Cable Drain Ell Locking Pin)
into drain ell.
(3.) OvErflOw assEmbly
1. Remove Item 15 (Overflow Plate) by loosening Item 16 (Overflow Plate
Locking Screw) with a Phillips screwdriver.
2. Unscrew Item 14 (Cable Overflow Mounting Bracket) by rotating
counterclockwise.
3. Place overflow through the tub hole.
4. Re-attach Item 14 (Cable Overflow Mounting Bracket) by rotating
clockwise.
5. Install the two o-rings (see instructions below).
6. Re-attach Item15 (Overflow Plate) and secure with Item 16 (Overflow
Plate Locking Screw).
7. Leave at least a 1/8” gap between Item 14 (Cable Overflow Mounting
Bracket) and Item 15 (Overflow Plate).
(1.) attach tEE
Use Items 8 (Brass Slip Nuts
and Slip Joint Polywashers) to
tighten Item 10 (Brass Tee) to
Items 7 and 11 (Brass Piping).
Installation of O-rings
step 1:
Remove overflow plate
by inserting Phillips screwdriver
into hole in overflow plate and
loosening Overflow Plate Mount
-
ing Screw.
step 2:
Push both o-rings onto
Center Rotating Pin.
step 3:
Using small screw-
driver, push both o-rings into gap
between Center Rotating Pin and
the Wheel handle.
step 4:
Replace Overflow
Plate and tighten Overflow Plate
Mounting Screw.
1
(4.) POP-uP aDjustmEnt
1. Pop-up should open and close sufficiently; if not, adjust
Item 1 (Cable Stopper Adjusting Nut) as needed.
2. If the pop-up closes automatically, make sure both
provided o-rings were installed as shown below.
