BEACON SOUNDER
detection
watch
gas
8
4. GENERAL SPECIFICATIONS
DIMENSIONS
92 x 88 mm (3.6 x 3.5”) Dia x H
WEIGHT
250 g (8.82 oz)
MOUNTING
4x M4x35 bolts
COLORS
RGB LED, Red, Yellow, Green and Blue flashing patterns
SOUND
4 types of alarm sounds
SOUND PRESSURE LEVEL
107 dB @ 1 meter (3.3 ft)
POWER SUPPLY
9-30V DC (min. 4W)
STANDBY CURRENT
Max. 10 mA
TRIGGER VOLTAGE POSITIVE
6-30V DC
TRIGGER CURRENT
Max. 6 mA
CABLE DIAMETER
Max. 1,3 mm
2
Stranded core
5. SERIAL PROTOCOL SPECIFICATION
Specification rev 1.0
INTRODUCTION
This document describes how to control and connect the Beacon Sounder PN: Air-Be-
ac-010 over a serial interface. This serial interface can be used to select colour, display
effect and sound effect. If the serial input is used, the digital I/O inputs are no longer
enabled. The document contains source code that can be used as an example of how to
send commands to the Beacon Sounder.
CONNECTIONS
WIRING
The Beacon Sounder can be powered by
only one
of these options:
1. Use terminal J4 connect 9 – 30VDC (min 10W) to the + and – terminals
2. Use terminal J2 to connect a 5VDC (+/- 0.1V) 2A power supply. This input has no pro-
tection against overvoltage or supply reversal. Use at your own risk.
J2 PINOUT
PIN
CONNECTION
1
+ 5VDC Power supply
2
TX Signal
3
Do not use
4
GND
NOTE
Cable length of TX signal may not exceed 500mm wire distance form signal source.
The signal voltage should be 3.3V TTL/CMOS.
CONNECTOR & CRIMP
DESCRIPTION
PART NUMBER
MANUFACTURER
WIRE-TO-BOARD RECEPTACLE
22-01-2045
Molex
CRIMP CONTACT GOLD PLATED
08-55-0111
Molex
DIPSWITCH SETTING
Set DIP switch FN 3 to “ON” to configure the Beacon Sounder to use a serial input.
DIP SWITCH 3 FN
Function
ON = J2 TTL Communication protocol
OFF = J4 terminal block input
PROTOCOL
SPECIFICATION FOR COMMUNICATION
ITEM
VALUE
BAUD RATE
9600 8N1
FLOW CONTROL
None
SIGNALING VOLTAGE
3.3
DocuSign Envelope ID: AD1219C0-C292-4C55-B2EE-1190F300B975
