6-16-19, JINGUMAE, SHIBUYA-KU, TOKYO 150-0001, JAPAN
TEL: +81-3-3400-6147 FAX: +81-3-3409-3156
2/4
ＩＭ０８７３
-
００
●
Do not change settings during operation.
●
The settings of this product can be stored in a DAT file.
The settings also can be loaded from a DAT file to this
product.
However, do not load the settings from the
DAT file that was created or edited with use of other
than the setting tool to this product. Failure to
observe this may cause malfunction or trouble, and
then, we cannot guarantee proper operation of this
product.
* Refer to the instruction manual for the setting tool for
further information.
7) Caution other than the above
●
It takes 30 minutes to assure full performance of this
product even this product can be operated immediately
after turning on the power.
4. Dimensional Drawing
5. Circuit Configuration
6. How to Mount
When mounting the product on a wall, refer to the installation
dimension diagram.
The diagram below shows the minimum mounting clearance
between adjacent units.
7. How to Connect to/Disconnect from
DIN Rail
1) How to secure the socket
Engage the hook on the rear upper
side of the socket with the rail with
the slider on the bottom side of the
socket downward, and press the
lower side of the socket in the arrow
direction as shown in the drawing to
secure the socket.
2) How to secure the main unit to
the socket
Position the main unit so that the
characters in the front label can be
read in the appropriate direction,
press the main unit into the socket,
and screw the main unit to secure it.
3) How to disconnect the main unit
from the socket
Loosen the screws that secure the
main unit, and pull the unit out in a
straight line.
4
) How to disconnect the socket
Put a flat head screwdriver into
the slider slot of the socket and
pull the lower side of the socket
in the arrow direction
②
while
pulling the screwdriver in the
arrow direction
①
.
8. How to Connect
Terminal
No.
Sign
Description
1
INPUT1
+
These terminals receive the
specified
input signals.
3
COM
-
4
INPUT2
+
2
No.2
OUTPUT
+
Signals are provided in accordance
with the input/output specifications.
(*1)
5
-
6
NC
No connection
7
No.1
OUTPUT
+
Signals are provided in accordance
with the input/output specifications.
9
-
8
NC
No connection
10
POWER
U(+)
Connect the rated voltage power
supply.
11
V(-)
*1 NC (no connection) for F2AL
* No line shall be connected to NC.
