Doc. P/N:
WSP-009-008
Version: V1.3
Issue Date: April 2014
Operator Manual
Chart Display Modes
29
Show Profile
Window
When this button is enabled, the Profile Window is displayed.
The Profile Window will show a profile of the detected seafloor
between the two points determined by the ‘Add Measure’ tool.
The mouse pointer can be used to determine the depths at points
along the profile
Cursor showing depth
reading on the profile
Depth difference
between the shallowest
and deepest points on
the profile
Shallowest profile
reading
Deepest
profile reading
Distance along profile from
measure point #1 to cursor
Close the Profile
Window
Figure 12. Profile Window
3d m
aster
Enabling this button will set the active 2D display to be the
master of the 3D display. This means that the 3D display
will be drawn dependant on how the 2D display is setup
(including the draw distance and map resolution of the 2D
display).
i.e. If the 2D display is showing colour depth, the 3D display
will show colour depth. See the example in Figure 13.
3D Master Enabled
-
the 3D display above
is linked to this 2D
display.
Figure 13. 3D Master
