Pre- Installation
Page 3 - 4
Need help? Send us an email at: [email protected]
1. Check the ground before installing the device; frozen or waterlogged ground is not
recommended.
2. For the first time use, charge the mole repellent for at least 6 hours where the solar
panel of mole repellent can receive at least 6 hours of sunshine.
3. Choose a location that gets plenty of sunshine for ensuring that the battery gets
charged thoroughly and produces the best results.
Installation
1. Dig a small hole to make room for the solar repellent. DO NOT use excessive force when
installing as it might break the device.
2. Push the repellent (making sure the solar panel is facing upwards) into the soil and
leave about 2-4 inches out of the ground to avoid the whole unit from being immersed
in heavy rain.
3. A hammer can be used for this purpose but to do that, insert a piece of wood between
the upper part of the repellent and the hammer. In case the soil is hard, drill a hole first
with a chisel or a piece of wood or similar item before attempting to push the spike into
the ground.
4. Push the “On/Off” switch to the On position. After this action, you may hear a buzzing
sound for a few seconds. The buzzing sound will disappear afterwards, and the
repellent will start emitting sonic waves.
5. Make sure to keep the power on when charging.
6. Since the range of this repellent is only 15 meters, you will need to use several of the
same units to cover an area that is larger than 15 meters.
∙ Loose hardware.
∙ Cracked or broken parts.
∙ Any other condition that may affect its safe operation.
Maintenance
BEFORE EACH USE:
Inspect the general condition of the Dartwood Solar Mole Repellent and check for: