10 Troubleshooting
Fault
Cause
Solution
Wapo-Mat III does not
heat up
Dirty level sensor
Clean level sensor
Water level too low
Add water
Water-level LED comes
on and warning tone
sounds fig,: 1.
Dirty level sensor
Clean level sensor
Water level too low
Top up water until control light goes
off
Re-calibrating the touch
display
Turn the unit on and while the
Wassermann logo appears tap the
touch display twice. This will take
you to the self-explanatory touch
panel calibration process.
Fig.: 2-3
Programme not starting
although set temperature
has been reached.
In mode (a)
the unit intentionally
overheats by 1°C and waits
briefly to validate the value.
This is not a fault, please wait
roughly 45 sec.
If the above recommendations do not solve the problem, contact your dental depot
or our service department.
15
Figure 2
Figure 3
Figure 1
Summary of Contents for Wapo-Mat III
Page 1: ...Polymerisation Unit Wapo Mat III USER MANUAL...
Page 20: ......