washloo Odyssey, User Manual, Page: 14 / 23

Odyssey – Description Functions
Note : The above illustration is an example only, your version may vary
Sound Settings
The sound will be on by default.
There is a BEEP when the bidet has received
commands or signals from the remote control or the
side control, also when being seated and leaving the
seat sensor.
To turn off the BEEP, open the seat cover without
being seated, pull out the Side Control knob and
turn it in the anticlockwise direction. The sound will
be turned off with a long BEEP.
To turn it back on again repeat this process.
User Settings
Saving the User settings once the Washloo has been
used, can be done in the following Process;
1. Press and hold either ‘User 1’ or ‘User 2’ button
on the remote control for more than 3 seconds
to save the settings to ‘User 1’ or ‘User 2’. This
will save the Users ‘Water’ and ‘Dryer’
Temperature settings, ‘Position’ and ‘Pressure’
settings also.
2. To use the preferred setting saved by the User
in either ‘User 1’ or ‘User 2’, Simply press ‘User
1’ or ‘User 2’ button on the remote control.
This will the cycle and use the preferred
operating ‘Water’ and ‘Dryer’ Temperature
settings, ‘Position’ and ‘Pressure’ on demand.
Standby Power Setting
With no one seated on the Washloo,
Press and hold the middle button on the Side
Control for 6 seconds.
The Washloo will then enter the power standby
mode . Press and hold again for 6 seconds to restart
the Washloo once again.
12