FIGURE 1 OPEN NETWORK
6.0 CONFIGURATION
6.1
Configuration by Hard Wire Link
The modem can be configured by connecting a dumb terminal to the modem with following
settings:
9600
Baud
No
Parity
1 Stop Bit
Local
Echo
XON/XOFF to OFF
RTS/CTS to OFF (no handshaking)
Remove the power from the modem and connect 0v to pin 6 on the modem D Connector.
When the power is reconnected the following will appear on the screen:
WARWICK IND ELEC
X7200 MODEM *.*
BAUD PARY O/E REPT ERR DDR TXAD RXAD RFC TXON FX
?
B N O N N N OO
OO
Q N F
Y/N
6.2
Configuration by Terminal Access
If the current configuration is known then the modem can be configured without the use of a
link between pin 6 and 0V.
Connect a dumb terminal to the D connector with the same baud rate and parity as that
already configured in the modem.
Switch the modem off and then on again.
Press the $ key and then the ESC key. The following will appear on the screen:
WARWICK IND ELEC
X7200 MODEM *.*
