MOD
The
RockBoard®
MODs offer you the one solution you will ever need to organize all the connections to and from your
RockBoard®
.
Fitting all
RockBoard®
’s,
except the Duo 2.1
, each MOD has various cable connections to fit a wide variety of needs as a convenient ‘thru box’.
RockBoard®
MODs allow you to hook up your pedals permanently underneath your board and have a central access point for your instrument,
amp and power supply. You are using TRS, XLR, MIDI or USB in your setup? We’ve got you covered!
The
RockBoard®
MODs provide you with all the connections you’ll need.
Installation is as easy and convenient as it gets:
Depending on your choice, the
RockBoard®
MODs offer different options, but let’s start with the ones they have in common:
•
TRS In/Output: You can use these for MONO, STEREO or Balanced Inputs or Outputs, Effects Loops, Looper Switcher and
basically anything that uses a 1/4” jack.
•
IEC In/Output: This allows you to connect the AC IEC of your multi-power supply.
Here are the connections only found in MOD1:
•
XLR In/Output: These are implemented for any instrument going through a DI straight to mixing board or
players implementing their FX-pedals for recording to connect to their Audio Interface
•
DC In/Output: Some multi-Power supplies use an external power adapters instead of an AC IEC cable,
like the
RockBoard®
Power Block or the MXR M238 ISO-Brick
TM
* Power Supply for example. We’ve got that covered, too.
MOD1 Connections:
5x TRS In/Output
And here the connections unique to MOD2:
•
MIDI Thru: These two allow you to route MIDI commands to and from your pedalboard via an audio interface to your PC or Mac.
You can Program setups and scenes comfortably from your workstation and load them into your MIDI capable devices
on your
RockBoard®
.
•
USB Thru: Just like with MIDI, you can control and save/load presets without removing your FX pedals from your board.
MOD2 Connections:
dual manuals
1
+
2
MOD
1
MOD
2
9V
Input
AC IEC
Input
9V
Input
5x TRS In/Output
5x TRS In/Output
MIDI
Thru
AC IEC
Input
5x TRS In/Output
USB
Thru
AC IEC
Input
MIDI
Thru
USB
Thru
STEP 2
Load your chosen
MOD from the front
into the cavaity. Using
a pencil, mark the
spots where you need
to drill the holes in the
board.
STEP 1
Remove the rubber
frame of your
RockBoard®
’s front
cavaity.
STEP 4
Secure the MOD
with the two included
screws.
That’s all, now you
are ready to go!
STEP 3
Take the MOD out
again and carefully
drill each hole.
AC IEC
Input
XLR
In/Out
XLR
In/Out
* M238 ISO-Brick
TM
Power Supply is a registered T
rademark by Dunlop Manufacturing, Inc.
