www.warriorwinch.co.uk
www.warriorwinch.co.uk
RADIO REMOTE CONTROL 2 COMMAND
USER AND MAINTENANCE MANUAL
WARNINGS
This manual is an essential part of the device and it should be thoroughly kept for later consultation.
Carefully read the warnings contained in this manual, concerning safety and a proper preservation of
the product. These warnings are ALWAYS to be carefully read before using the device. Winch Solutions
Ltd declines all responsibility for any trouble arising from the non-compliance with these warnings.
•
Do not travel with the device switched on.
•
Connect the system only to the vehicle’s battery.
•
Before carrying out any mechanical maintenance operation (welding) on the
vehicle, disconnect the battery clips.
•
Avoid attempting to repair the device by yourself. Repairs performed by
unskilled people can cause serious damages or failures. For assistance, apply
to your local authorized service centre.
•
Use only original spare parts.
•
Always keep at a safe distance from the moving parts.
• Number of outputs: 2
• Frequency bands: ISM 868/915 MHz
• Microprocessor electronics control.
• Dimensions: 190 x 83 x 22 (with antenna).
• Grade of enclosure: IP67.
• 12/24 VDC (10-30 allowed) rating power supply through connection to the vehicle’s battery.
• Typical quiescent current:- 18 mA a 12 V; - 14 mA a 24 V.
• Integral resettable fuse: 7 A
• Maximum suppliable current for each channel: 5 A
• Maximum total suppliable current: 7 A
• Receiver category (EN 300-220-1): 2
• Protection of battery inversion polarity.
TECHNICAL FEATURES
SYSTEM CODING
It is necessary to code the system only if you have to replace the transmitter unit or if you want to use
it with a diff erent receiver from the one it was purchased with.
Follow the instructions to code the system.
1.
Take the power supply off the receiver.
2.
Disconnect the white or gray cable from negative pole of the battery and connect it to the
positive pole of the battery.
3.
Put power into the receiver. The led on the receiver start to blink.
4.
Press any 3 keys at the same time on the radio control transmitter within 15 seconds since it has
been switched on (also more times if it is necessary).
5.
At this point, the coding occurred. The led on the receiver turn off .
6.
Take the power supply off the receiver.
7.
Disconnect the white or gray cable from positive pole of the battery and connect it to the
negative pole of the battery.
8.
Put power into the receiver with the connector inserted to verify correct operation (press key
START on the transmitter and abilitate the outputs).
INSTRUCTIONS FOR WIRING CONNECTION
To operate from the transmitter, consult the
user manual of the transmitter coupled with the
receiver.
NOTE: It is necessary to connect the white cable
with the black cable to the negative pole of the
battery.
NOTE: It is necessary to connect the grey cable
with the black cable to the negative pole of the
battery.
5 WIRE CONNECTION
WIRE
FUNCTION
Green
OUT 1
Yellow
OUT 2
White
Pairing
Red
+ Alimentation
Black
- Alimentation
7 WIRE CONNECTION
WIRE
FUNCTION
Green
OUT 1
Yellow
OUT 2
White
Master Output
Pink
Emergency Output
Grey
Pairing
Red
+ Alimentation
Black
- Alimentation
