Page 9
For technical questions, please call 1-888-866-5797.
Item 56434
Maintenance And Servicing
Procedures not specifically explained
in this manual must be performed
only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: Turn the Power
Switch of the tool off and unplug the tool from its electrical outlet before performing
any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE: Do not use damaged equipment. If
abnormal noise or vibration occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1.
DISCONNECT from power outlet and make
sure that it is completely cooled.
2.
BEFORE EACH USE,
inspect the general
condition of the Heat Gun. Check for loose screws,
misalignment or binding of moving parts, cracked
or broken parts, damaged electrical wiring, and any
other condition that may affect its safe operation.
3.
AFTER USE,
clean the external surfaces of
the tool with a clean, moist cloth and mild
detergent. Then dry. Do not use solvents.
4.
WARNING!
All maintenance, service, and
repairs not mentioned in this manual must only
be performed by a qualified service technician.
5.
WARNING! TO PREVENT SERIOUS
INJURY: If the supply cord of this power
tool is damaged, it must be replaced only
by a qualified service technician.
Troubleshooting
Problem
Possible Causes
Possible Solutions
Heat Gun will
not turn on.
1. Power Switch set at “0”.
2. No power at outlet.
3. Cord not connected.
1. Turn Power Switch to “l” or “ll”.
2. Check power at outlet.
3. Check that cord is plugged in.
Unsatisfactory results.
Improper heat setting.
Adjust heat setting (“l” or “ll”)
for correct application.
Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect power
supply before service.
