Protecting Your Adventure Lifestyle
========================================================================================
●
●
●
Warrior Products, Inc.
11100 SW Industrial Way
Tualatin, OR 97062
Phone: (888) 220-6861
Fax: (503) 692-0364
Fig. 2
Fig. 1
10103 – MOD rack small Platform
INSTALLATION SHEET
Kit Contents:
Item
Qty
Item
Qty
Platform Latch Assembly
4
3/8” x 1” Hex bolt
16
10603 Platform
1
3/8” Nyloc nut
16
1/4” Lynch Pin
4
3/8” USS flat washer (used for both 3/8” and 7/16” bolts)
32
Installation Instructions:
1.
Prepare the platform by attaching the quick-release latches. Attach a latch to each of the four mounting
locations in the corner plates of the platform using four 3/8” x 1” Hex bolts, eight washers, and four 3/8” Nyloc
nuts per latch as shown below in Figure 1. Place the bolts at the outer corner slots of each rectangular
mounting slot pattern. Install the hardware, but do not fully tighten at this time. Tighten the hardware enough
to hold the latch close to the platform corner plate, but loose enough to slide around slightly.
2.
To prepare the platform and latches to be lifted
onto the rail, you may find it beneficial to swing the
silver latch hooks all the way out and screw them
against the latch handle body until they stay in
position (Fig. 2). By tightening the latch hooks
against the latch handle (screwing them in by
turning clockwise), you prevent them from dangling
and getting in the way when setting the latches on
top of the rails.