============================================================================================================
If you need further assistance installing your product, please contact us by email at
(888) 220-6861. For more accessories visit
THANK YOU FOR PURCHASING WARRIOR PRODUCTS
QUALITY
●
INTEGRITY
●
INNOVATION
●
SERVICE
Warrior Products, Inc.
11100 SW Industrial Way
Tualatin, OR 97062
Phone (888) 220-6861
Fax (503) 692-0364
a.
You will have to rotate the fog light 90 degrees so that the (4) mounting tabs are vertical to have enough
clearance to insert the fog light.
b.
Once both sets of tabs have cleared the back opening, rotate the light back 90 degrees aligning the
mounting holes of the fog light with the mounting studs of the Light Bucket (make sure to rotate the correct
direction to align the offset hole and stud). Place the light over the mounting studs of the Light Bucket.
3.
Loosely thread four #10-32 KEPS nuts onto the four
threaded fog light mounting studs. (
FIGURE 5
)
4.
Center the fog light in the Light Bucket front
opening and gently tighten the four #10-32 KEPS
Nuts with a 3/8” wrench. Over-tightening may
damage the plastic housing tabs,
DO NOT OVER-
TIGHTEN
!!! Periodically check that all mounting
hardware is snug. (
FIGURE 6
)
5.
Repeat steps 2-4 to install the second fog light into the second Light Bucket.
Light Bucket Installation Instructions:
6.
Place the Light Buckets into your Warrior Products front bumper making sure to slide the four threaded posts on the
back of the Light Bucket through the four corresponding holes in the bumper socket. For proper aiming, the
adjustment knob should be located on the bottom of the bucket (toward the ground).
7.
Thread four #10-32 Nuts onto the four studs on the back of the Light Bucket after passing them though the holes in
the bumper socket.
8.
Visually align the Light Bucket in the bumper. Evenly and gradually tighten the four #10-32 Nuts per Light Bucket.
9.
Extend your fog light power wires if needed by splicing in an additional length of wire.
10.
Plug the power wires into the bulb sockets.
11.
Turn on fog lights to verify connections and fine tune the vertical aim of each light by turning the adjustment knob
(SEE
FIGURE 4
) from the back side of the bumper to raise or lower the beam.
12.
Installation is complete.
FIGURE 5
FIGURE 6
INSTALLED ORIENTATION
FIGURE 4
ROTATE 90˚
TABS PAST OPENING
ROTATE BACK 90˚
ADJUSTMENT
KNOB
ADJUSTMENT
KNOB
