Warrior, Inc.
11100 SW Industrial Way
Tualatin, OR 97062
Phone: (888) 220-6861
Fax: (503) 692-0364
4.
Prepare the Rain Gutter Mounts for
installation by loosening the Clamp Screws (2
per mount) and the Adjustment Screw (1 per
mount) so that the mount will open enough
to fit over the rain gutter of the vehicle. In
some cases, the Rain Gutter Mounts may
need to be partially disassembled in order for
them to fit over the rain gutter.
5.
Place the Platform in the desired position on the roof and use wooden blocks (or equivalent)
to space the Platform off of the roof at the approximate height of the mounts.
6.
Use the supplied rubber edge trim installed on the edge of the large inside piece of the mount
(the edge that will sit inside the rain gutter channel) whenever possible. You may install the
mounts without the rubber edge trim if more grip range is required to clamp to the rain
gutter.
7.
With the Platform positioned, install each mount, one at a time over the rain gutter at the
mounting bucket locations on the Platform. The mounts will be positioned under the Platform
mounting bucket. Align the bolt holes of the mount with the center row (front to back) of slots
in each platform mounting bucket.
8.
Note the holes on top of the Rain Gutter Mount, which will be used to bolt the Gain Gutter
Mount to the Platform. You may need to use different hole locations for each set of Rain Gutter
Mounts due to the vehicle width variation, but make sure that the Rain Gutter Mounts are
symmetrical from side to side.
(Jeep Cherokee shown above for illustration pursposes)
9.
Loosely attach each mount to the Platform using (2) two 3/8” x 1” hex bolts with washers down
through the Platform mounting bucket (middle row of slots front to back) and Rain Gutter
Mount.
10.
Place a second washer and Nyloc nut on each bolt under the Rain Gutter Mount surface. Do
not tighten hardware at this stage.
