Warner Electric • 800-825-9050
P-0362-WE • 819-0551
3
1. Using a 1/4” drill, drill a hole in the center of the
dancer pivot shaft 1/2” deep.
2. Drive the supplied pin into the hole in the shaft until
half its length remains exposed.
3. Assemble the brackets and mount the sensor on the
bracket.
4. Position the sensor and bracket on the machine
so the sensor shaft and the pin are aligned and
separated by 1/8 to 1/4 inch. While holding the
sensor and bracket in the above position, mark the
centers of the bracket holes on the machine. Drill
and tap holes in the machine for 8-32 screws.
5. Connect the sensor shaft to the pin with the flexible
coupling provided. The index mark on the sensor
shaft must be aligned with the index mark on
the sensor face when the dancer arm is near the
midtravel position.
6. Mount the sensor and bracket to the machine.
Connect the sensor to the tension control unit
with the cable assembly in accordance with the
instructions supplied with the control unit.
Bracket (see note 1)
.250/.253 Dia.
1/2 Deep
Dancer
Pivot
Shaft
1-11/16 Nom.
Coupling
Supplied
Pin Supplied
8-32 Screws
(3 supplied)
1-1/4
10-32 Screws
Washers & Nuts
(2 supplied)
3 Holes 3/16 Dia. on
1.50 B.C. Equally
Spaced
NOTES:
1. TWO BRACKETS ARE SUPPLIED
WITH EACH UNIT SO THAT THE
CUSTOMER CAN MOUNT THE
TCS-605-1 ACCORDINGLY.
2. BRACKETS ARE MADE FROM
14 GAUGE (.0747) STEEL
Replaceable Components
Sensor only TCS-605-1
7330-101-002
Cable assembly only
7330-101-001
.
15' Jacket
5/16
2 Dia.
4-3/8
