Warner Electric • 800-825-9050
P-2105-WE 819-0549 5/17
7
Clutch – Electrically Released Brake Wiring
(Power on clutch / power off Brake)
q
1 . Connect the Brake to Terminals 4 and 5 . Observe
the polarity when making
connections . Tighten Terminal 4 securely .
q
2 . Connect the Clutch to Terminals 7 and 8 . Tighten
Terminal 7 securely .
q
3 . Connect the switching for Channel 1 to Terminals
5 and 6 . Tighten terminals securely .
q
4 . Connect the switching for Channel 2 to Terminals
8 and 9 . Tighten terminals securely .
q
5 . Set DIP Switch, SW1 for proper current setting
before applying power to the control .
See Internal Switch Settings Chart for proper DIP
Switch settings .
q
6 . If external potentiometers are being used, then
proceed to the external potentiometer wiring section .
If they are not used, this
completes the wiring of the control .
q
7 . Double check all connections before
applying power .
(Figure 4)
4
5
6
7
8
9
2
3
1
2
3
1
or
G
H
N
120 VAC
G
H
N
120 VAC
Clutch
Brake
Channel 1
Channel 2
+
-
+
-
ER
External switching by
customer, see
specification.
Note: If Solid-state NPN switching
is used, emitter is connected to
terminal 6 or 9 and collector is
connected to terminal 5 or 8.
