Tension control system X2DRV
29/08/2012
X2DRV
Installation & Operation Manual
Page 2 of 5
Ratings:
Main Supply Voltage (V)
24V DC +/- 5%
Output
4A with Anti Residual
Operating T°C
-10°C to 50°C no Condensation
Compliance
General information:
Control chassis should be kept clear of all areas where foreign material, dust, grease, or all might affect the operation of the control.
Installation must be made in accordance with the instructions found in this manual. Failure to do so may damage the Driver.
This driver supports the following Warner brakes : TB’s, ATT’s, MPB’s, MPC’s. POB’s, POC’s and MTB’s brakes cannot be driven by this device.
Installation instructions:
Hardware Pin Out:
1
BK1+
Power Output
Brake 1
Integrated Anti-residual control. Voltage or Current controlled.
2
BK1-
Power Output
Brake 1 Output –
3
BK2+
Power Output
Brake 2
Integrated Anti-residual control. Voltage or Current controlled.
4
BK2-
Power Output
Brake 2 Output –
5
ON1
Analog input
Full power : 24VDC applied to brake 1
Active low / GND: NPN type Input
6
OFF1
Analog input
Power Off brake 1 : 0V applied to brake 1 with anti-residual
Active low /GND: NPN type Input
7
Gnd
Ground
8
ON2
Analog input
Full power : 24VDC applied to brake 2
Active low /GND: NPN type Input
9
OFF2
Analog input
Power Off brake 2 : 0V applied to brake 2 with anti-residual
Active low /GND: NPN type Input
10
Gnd
Ground
11
InBK1
Analog input
Brake 1 Input signal control.
Selectable: 0/+10V DC or 4/20mA.
12
Gnd
Ground
13
Ana1
Analog input
Brake 1 Auxiliary input : To compensate Brake1 signal in Open Loop control
Selectable: 0/+10V DC or 4/20mA.
Teachable Span (item 9 page 4).
14
Gnd
Ground
15
10V
Power out
External interface Power Supply. 10VDC, 100mA Output
Used to Power an external potentiometer to get an Open Loop control (local torque
adjust)
16
Gnd
Ground
17
InBK2
Analog input
Brake 2 Input signal control.
Selectable: 0/+10V DC or 4/20mA.
18
Gnd
Ground
19
Ana2
Analog input
Brake 2 Auxiliary input : To compensate Brake2 signal in Open Loop control
Selectable: 0/+10V DC or 4/20mA.
Teachable Span (item 9 page 4).
20
Gnd
Ground
21
10V
Power out
External interface Power Supply. 10VDC, 100mA.
Used to Power an external potentiometer to get an Open Loop control (local torque
adjust)
22
Gnd
Ground
23
24V
Power supply
24VDC Power supply Input
24
GND
Ground
GROUND
