4
Warner Electric • 800-825-9050
P-209-WE • 819-0517
These units are shipped with the armature, splined
armature adapter, and autogap already assembled .
The splined hub, retainer ring, and bushing are
shipped as separate parts .
Follow these instructions to assemble the armature
and splined hub:
Step 1
Place the armature-splined adapter
assembly on a flat surface with the
segmented side up .
Step 2
Push the splined hub, with the retainer
ring groove down, through the autogap
spring and splined armature adapter . (See
Figure 4 .)
Step 3
Turn the armature-adapter assembly over,
and insert the retainer ring in the groove .
(See Figure 5 .)
Step 4
Slide the armature-adapter assembly up
against the retainer ring .
Step 5
Insert the bushing into the retainer ring side
of the splined hub . The clearance holes
in the bushing flange should line up with
the tapped holes in the splined hub . (See
Figure 6 .)
D. Mounting the Armature and Hub
Assembly
1 . Slide the complete armature and hub
assembly onto the shaft until the armature
face touches the magnet face . (See Figure 7 .)
Figure 4
Figure 5
Figure 6
Figure 7
