WARN INDUSTRIES
PAGE 5
83688A0
©2009 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
Figure 4
4.
Remove the 2 fasteners securing the rear skid
plate at the rear of vehicle. Retain these
fasteners they will be used when installing the
new skid plate. Remove the rear skid plate at
this point, figure 4.
5.
Place the front skid plate into position as
shown in figure 5. Place the new skid plate on
directly over the factory skid plate. Use 2 M6-
1.0 flange head torx screws (B2) to secure the
rear two holes of the skid plate.
6.
Use 2 M6-1.0 flange head torx screws (B2), 2
M6-1.0 hex head flange nuts (B3) and to flat
washers (B4) to secure the two center holes
holes of the skid plate.
7.
The forward mounting hole will need to be
marked and drilled out with a 3/16 or 4.5mm
drill bit. Then use the M6-1.0 thread cutting
flange head torx screw (B1) to secure the front
of the skid plate.
NOTE:
Applying a small amount of thread
lock will help insure M6 bolts will
stay secure.
Figure 5
Figure 6
REAR FASTENERS
M6-1.0 FASTENER
M6-1.0 FASTENER
WASHER AND
NUT
DRILL, 3/16, 4.5mm
Summary of Contents for 83680
Page 8: ......
