WARN INDUSTRIES
PAGE 4
39526 Rev B1
The bracket should fit to the frame as shown in Figure #4.
FIGURE #4: FRAME MOUNT INSTALLATION
2. Plow Installation:
Slide the plow into position with the tubes under the ATV. Lift the end of the tube assembly into position so
the holes in the Tube Wings line up with the 3/8” holes in the frame bracket. A Phillips head screwdriver
may be used to align the holes. Insert both 3/8” pins and hook the retaining clips on the ends of the pins to
secure the plow to the ATV. If it is determined that the Plow is not straight with respect with the ATV, then
the nuts on the Frame Mounting Bracket should be loosened and the plow adjustments made to make it
straight. Then retighten and torque the nuts on the Frame Mounting Bracket to approximately 15ft.-lb (20
N-m).
CAUTION
When using a winch with this plow, read your winch operator manual before
proceeding with this installation. ALWAYS USE EXTREME CAUTION WHILE
WORKING WITH OR AROUND A WINCH AS SEVERE INJURY OR DEATH
MAY OCCUR.
A roller fairlead must be used for lifting and lowering the plow. Cable
damage will occur if a roller fairlead is not used.
FRONT OF BIKE