8
Step 3 -
Apply Mirror Demister
•
Position the demister on
the back of your mirror so
that it matches the markings
previously made on the wall.
•
Draw the outline of the
demister on the back of the
mirror.
•
Measure and record the
resistance of the demister
in the “Resistance Before”
column of the control card,
supplied as part of this
installation guide on Page 16.
•
Stop installation immediately
and contact Warmup if its
resistance falls outside the
range set out in the Reference
Resistance Band table on
Page 18.
•
Always handle mirrors with
care. Lay the mirror face down
on a protective soft surface.
•
The back of the mirror must
be clean, dry and free from
grease, detergents or polish.
•
Peel 50 mm off the protective
backing and position it so that
it lines up with your markings
on the mirror back.
•
Press the demister into the
back of the mirror smoothing
out any air pockets between
the demister and mirror using
a soft cloth or a sponge.
•
Gradually remove the rest
of the protective backing
repeating the previous step,
removing any air pockets,
ensuring you keep the
demister in line with the
markings you made on the
back of the mirror.
1
2
4
3