14
PLEASE READ CAREFULLY - ALWAYS
MAINTAIN SAFETY WHEN WORKING WITH
ANY APPLIANCE
Check that the mains voltage corresponds
with the rating of the appliance before
operating.
To protect against electric shock, do not
immerse cords, plugs or appliances in water or
any other liquid.
Do not leave any appliance unattended while
it is operating.
Close supervision is necessary when any
appliance is used by or near children or infirm
persons.
Unplug from outlet when not in useing or
before cleaning. Allow to cool before putting on
or taking off any parts.
Do not operate the appliance with a
damaged cord or plug, or after the appliance
has been damaged in any manner, if the
supply cord or appliance is damaged ,it must
be replaced by the manufacturer or
it is service agent on a similarly qualified
person in order to a hazard.
The use of accessory attachments not
recommended by the appliance manufacturer
may cause injuries.
Do not use outdoors.
Do not let the cord hang over the edge of a
table or counter or let it come into contact with
any hot surfaces
To disconnect-remove the plug from the
outlet. Do not pull plug out by the cord.
Do not use this product for anything other
than it is intended use. This appliance is for
household use only.
No liability can be accepted for any damage
caused by non compliance with these
instructions or any other improper use
mishandling.
Ensure the Convector is on an even surface
between the Convector and objects in the
room Should be at least 50cm.
Don not cover the Convector, do not let
combustible objects near or touch unit.
When the unit is running, at first you will hear
a small noise . This is normal and does not indi
-cate a faulty unit Unpack the Convector and
make sure to remove all packaging and
dispose of correctly.
Remove the Feet from the box and attach to
underside of the Convector with the screws
supplied.
OPERATION INSTRUCTIONS
a)Connect the appliance to the mains.
b)Turn to the maximum the thermostat
switch
c)select the desired temperature by pressing
power switch (750W/1250W/2000W)
d)When the desired temperature has
been reached ,turn left the thermostat until the
appliance will be on and off by itself on the
selected temperature previously.
INSTALLATION
Before switching on the appliance and in
order to assure its correct performance, set the
feet-support.
(1)To the lower parts of the apparel,
matched at the same time, inside the grooves
of the metallic cover.
(2)Then fix both by means of the screws
soothed with the appliance.
MAINTENANCE
1)Donot cover the outlet as it might
cause overheating.
2)Always maintain clean the outlet and
inlet grilles.
3)Disconnect the appliance from the
mains before cleaning.
4)Clean the outer pan of the appliance
with a soft cloth gently wet. Never use abrasive
nor dissolvent.
5)Never hand the appliance with wet
hands.
6)When the appliance is on again after
a long tine bing stopped, a burn smell will
probably give off, due to the dust on the
resistances.
TECHNICAL ASSISTANCE SERIVCE
All the appliance have been checked
before leaving the factory ,Despite of it ,if you
observe a failure, remember that the Technical
Assistance Service will remain at your request.
If the plug has electricity
If all instruction for the starting
have been observed .
After these operations, if the appliance
should not work ,do not hesitate in calling us
,providing us model and serial number.