Warmtec EWN-500, User Manual

Page: 19 / 28

19
User manual - convector heater
TIPS FOR USING THE DEVICE PROPERLY
If the heater is stored or transported at low temperature (when dew drops form), it must be
allowed to run for at least 2 hours at room temperature before connecting the heater to the
power supply.
Placement of the device
Determine where the heater will be used. The heater should not be installed in rooms
exposed to drafts, under ventilation openings, in direct sunlight. The heater should be
placed on a smooth, solid surface.
20
cm Min
50
cm Min
20
cm Min
50
cm Min
20
cm Min
Before connecting the heater to the socket, make sure that its parameters are correct (AC
230 V, 50 Hz, earthed socket).
!
The heater must not be installed under an electrical socket.
Under no circumstances can the heater be placed on the floor without screwed
feet.
!
!
Do not connect the plug and do not operate the heater before installing the device
on the wall or before mounting the feet.
When mounting on the wall, keep the appropriate distances between the heater and any
other objects in the room, as well as walls, ceiling and floor.
Thanks to the fact that the degree of protection of the heater is IPX4, it can be installed in
the bathroom. Remember to install it in the appropriate zone of the bathroom. In the case
of the degree of protection IPX4, the device can already be installed in the zone 2.