Warmos installation and user guide 3
Wall mounting
Note safety distances when mounting the heater on a wall. The safety distance is 50mm on each side and 100mm upwards
and forwards. The recommended minimum height is 50mm off the floor. The thermostat adds 50mm to the width. The
distance from the wall to the front surface of Walo heaters is 110mm and 75mm to the front surface of Warma and Wahva
heaters, when the wall brackets are in place,
but 100mm to the thermostat’s front surface.
Follow the local regulations and
other applicable standards when placing the heater in damp locations. The heater must be fixed to the wall using the
supplied wall brackets. Do not position the heater underneath an electrical socket. Make sure that the wall type, material
and condition are suitable for fixing the heater.
1)
Place the heater on the floor against the wall with wall brackets in place.
2)
Check the correct mounting location. Mark the locations of the top ends of the wall brackets on the wall.
3)
Remove the brackets off the heater and place them upright on the floor to the points you marked.
4)
Tighten the screw in the upper big fastening hole of the left bracket standing on the floor against the wall.
5)
Remove the bracket and set it to rest on the screw by the lower keyhole of the bracket. Tighten the upper screws.
6)
Repeat the same for the right-hand bracket. The heater is now placed a minimum of 50mm off the floor, as
recommended.
7)
Mount the junction box to the wall according to the following instructions. Then place the heater in the wall brackets
horizontally.