STEP 8
:
Insert long screw (h) through
mounting bracket (g), then screw into plastic
drywall anchor (f).
Note: the two larger brackets are designed to be
used to secure the mounting shelf. The smallest
bracket should be used to secure one of the
mounting tubes, while the other is secured by the
power-source faceplate with mounting bracket.
STEP 8
STEP 9
:
Install the tube (a and b) onto the
bracket (g).
STEP 9
STEP 10
:
As shown in the picture, install the
set screws (c) into the hole of all the tubes (a,b
and k) using the allen wrench; fix the tube (a,b
and k) onto the mounting bracket (g).
STEP 10
Installation Support • (800) 875-5285 • WarmlyYours
INSTALLATION GUIDE
For TWS1-HRN08 hardwired towel warmers
STEP 5
:
Use a tape measure to measure the distance
between the center points of each wall bracket tube;
record the distances between points AB, AC, CD, and
BD. Mounting point C will determine electrical box
location. See Electrical Assembly in following
instructions.
STEP 5
STEP 6
:
Mark A, B, C, and D according to the data from
Step 5; It is suggested that this product be installed at
least 23.5 inches (59.69 cm) above floor level.
(WARNING: The electrical connection should avoid all
water). This mounting location must comply with all local
building and electrical codes.
Place towel warmer on the box (or a large sheet of paper)
and lay on a flat surface with mounting tubes facing
downwards. Mark the location of the following:
• The electrical collar (hardwired model only)
• The location of the mounting tubes
Use the template as a guide to mark the wall with the correct
locations of the four mounting tubes (A, B, C, and D)
STEP 6
STEP 7
:
Drill A, B, C, and D holes with an
appropriately sized bit. Use a hammer to knock
plastic drywall anchor (f) into wall completely.
STEP 7
ALTERNATIVE TO STEPS 5 & 6
A
B
D
C
A
D
C
B
