INSTALLATION
This appliance must be installed in accordance with the instructions in the
manual and the NEC guidelines relating to electrical fi xtures in bathrooms.
We recommend that the Towel Warmer be plugged into a GFCI protected
circuit.
Install the Towel Warmer as close to an electrical outlet as possible. If an
extension cord becomes necessary, always use a grounded 3-wire extension
cord. Confi rm that the cord’s electrical rating is at least as high as the electrical
rating of the Towel Warmer. Ensure that the extension cord is a suffi cient length
to reach the outlet so as not to put undue strain on the cord. Use caution
when arranging the cord to prevent tripping, snagging, or unintentional pulling
(especially by children).
Tools Required
•
Drill, Cordless or otherwise -
Use to make holes in dry
wall and studs as required
•
Phillips # 2 Screwdriver or Phillips # 2 Drill Bit -
Use to tighten the mount with screws into the
drywall anchors
•
Hammer -
Use to sink the anchors into the drywall
•
Hex Key Set, US -
Use to tighten the mounting hardware
bolts onto the pivot model of Towel Warmer (TW-E4PCP)
•
Level -
Use to make sure that the Towel
Warmer is mounted level
•
Yard Stick or Tape measure -
Use to measure the distance
between Towel Warmer mounting brackets to ensure that
they mount in line
Note:
Use other mounting hardware suitable for wall substrate when
required.
2
