8
CUSTOMER SUPPORT TEAM:
+44 (0) 333 220 6056
ATTACHING THE LEGS TO THE MAIN UNIT
1. To begin attaching the legs, first turn the
fire on its side.
2. Place a leg on each corner and use 4
screws for each leg.
3. Tighten the screws clockwise until tight on
each leg.
4. Pull the unit back up to a standing
position, making sure it is stable.
5. Place the unit in the required location and
plug it into a power socket.
6. The appliance is now ready for use.
CONTROL PANEL
1. ON/OFF – Turns the appliance and the
fame effect on and off.
2. Flame Adjustment – Controls the
brightness of the flame effect.
3. Temperature Control – Controls the unit’s
heating temperature.
NOTE: The flame effect can be operated
independently from the heating element. To
turn down the temperature without turning off
the flame effect, rotate the temperature control
dial to the left, but leave the flame adjustment
dial turned to the right. This will allow the flame
effect to continue working while stopping the
heat output from the unit.
USING YOUR APPLIANCE
1. Plug the heater into the mains and switch
it on. Press the ON/OFF switch to turn it
on.
2. Use the flame adjustment dial to select the
brightness of the flame.
3. Use the temperature control dial to select
your desired temperature.
4. When you have finished using the heater,
turn the temperature control dial to the
lowest setting to power down the unit.
5. Turn the appliance off by pressing the ON/
OFF button. The light on the button will
turn off to indicate the heater is powered
down.
6. Unplug the heater at the mains and switch
off the socket.
AUTO SAFETY CUT-OFF
This appliance automatically regulates its own
temperature so that it does not overheat.
The heater will automatically turn off when it
reaches an unsafe temperature. If this occurs,
switch the heater off, unplug it at the mains and
allow it to cool. The appliance will be safe to
use once it reaches a safe temperature again.
• For safety reasons, the fire will NOT
automatically reset when the auto safety
cut-off is enabled.
• To reset the appliance, disconnect the
appliance from the mains supply for at
least 15 minutes. Once sufficient time
has elapsed, reconnect the supply to the
mains and turn the appliance back on.