9
www.warmlite.co
6. Carefully lift the appliance up, ensuring
that the top rear ledge of wall fire
engages with the wall bracket and is
sitting centrally. This process should be
carried out by two people to avoid injury
or damage to property or the appliance.
Do not let go of the appliance until
you are sure it is safely attached to the
bracket.
7. Gently bring the wall fire down against
the wall. Mark the lower fixing brackets
two fixing hole positions on the wall,
then remove the wall fire.
8. Drill the wall and insert the wall plugs.
9. Refit the wall fire to the wall and
fasten the bottom fixing bracket to
the wall using the screws provided to
permanently fix the wall fire in place.
10. Remove the front panel and unpack the
logs from the bag and place them along
the light unit in the desired position.
11. Put the front panel back in place.
USING YOUR APPLIANCE
Helpful advice before fitting:
The appliance can be operated either by the
switches located on the left hand side of the
fire under its canopy or by the supplied remote
control.
MANUAL OPERATION
The On/Off switch is must be switched to ‘I’ to
begin operating the fire.
Operation is via by the buttons located on the
left hand side of the fire under the canopy.
The fire will beep to indicate that it is powered
up.
• Turn on the appliance by pressing the
Power switch on the main unit.
• To activate the flame effect, press the
Flame button. The indicator light will
illuminate, this can be activated without
the heater operating.
• Press once for a low brightness setting,
the next two presses of the button will
increase the brightness.
• A fourth press of the button will switch the
flame effect off.
• The fan heater has two separate settings
that are selected by pressing each
Function button.
• Pressing Button One selects the 1000W
heat setting, the Heat 1 display will
illuminate.
• Pressing Button Two selects the 2000W
setting, the Heat 2 display will illuminate.
• To turn the heater off press the Function
button again and set the power switch
to 0.
REMOTE OPERATION
Press once to turn the appliance
and flame effects on. Pressing
again turns the appliance and
flame effects off.
Press to cycle through the three
flame effect settings.
Time calibration settings. If not
set the timer effect will start from
00:00.
Press once to reduce the light
brightness. Pressing again turns
the light off.
Press once to activate 1000W
heat, pressing twice activates
2000W. Pressing again will turn off
the heating.
Open window On/Off.
Press to turn the Timer settings
On/Off.
Timer setting. You can set two
time periods and temperature
which set using the