7
www.warmlite.co
ASSEMBLY
1. Position the heater upside down being
careful to keep it stable.
2. Press a wheel into one of the holes on
the foot base and then place a screw into
the centre. Then screw in tightly with a
screwdriver.
3. Repeat for each other leg.
4. Carefully turn the heater the right way up.
POSITIONING OF THE HEATER
The heater should only be operated at a
minimum distance of 1 metre from any wall or
other object. Always position the air flow so
that it will optimise the heating of the room.
USING YOUR APPLIANCE
Note:
When switched on for the first time a
slight odour may be emitted for a few minutes.
This is harmless and occurs with most
appliances as slight traces of dust or lubricants
may have collected during manufacture.
5. Place the heater on a level surface in a
stable upright position.
6. Ensure power switches are in the “O”
(OFF) position and the thermostat is also
in the “•” (OFF) position.
7. Unwind the power cord and plug your
heater into a power socket (observing
the instructions regarding positioning).
Ensure the voltage on the specification
plate is the same as in your home and the
power cord is lying safely on the ground.
8. Switch the heater ON by selecting:
• Power setting I – 1000W
• Power setting II – 1500W
9. The heater operates when both the
power switch and thermostat function are
activated.
10. The red indicator light will turn on when
both thermostat control and power switch
are activated.
THERMOSTAT FUNCTION
1. Set the desired room temperature by
turning the thermostat dial clockwise to
the desired position. You may adjust the
temperature during use. To turn down the
thermostat turn the dial anti-clockwise.
2. To find the ideal thermostat setting for
3. your room, first set the knob to the
maximum position. As soon as the
temperature is comfortable, turn the
thermostat down slowly, until the heater
turns off. The heater will keep the
surrounding air at this set temperature
by switching on and off at intervals. The
indicator light lights up when the heater
is on.
4. To switch the heater off fully, turn the
power switches to “O” and the thermostat
to “•”. The indicator light will also turn off.