Warmlite WL42009 Manual Download Page 10

10

CUSTOMER SUPPORT TEAM: 

+44 (0) 333 220 6056

WALL MOUNTING YOUR HEATER

Your patio heater can be wall mounted for more 

permanent placing.
1.  To mount, remove the three screws from 

the base of the mounting plate at the rear 

of the heater.

2.  Use the pre-cut holes as guides for 

masonry screws and affix securely to the 

wall using 2cm screws and 1.5cm wall 

plugs. (not supplied)

3.  Make sure that the heater is well above 

head height and cannot be obstructed. 

Great care should be taken positioning 

the unit.

USING YOUR APPLIANCE

1.  Sit the heater on a flat, stable surface, 

making sure the heating element is away 

from any combustible materials e.g. 

curtains, furnishings etc.

2.  The pull switch cycles through 4 different 

positions. Select the appropriate position 

below: 

Position 0: Stop 

Position 1: 650W (normal power) 

Position 2: 1350W (intermediate power)

Position 3: 2000W (full power)

Note:

 The heater is equipped with a safety 

tilt switch. This will switch the heater off if it is 

tipped over.
3.  When you are finished using the heater 

switch off all elements.

4.  Allow the heater to fully cool and unplug 

from the mains supply before carrying or 

cleaning.

CLEANING AND CARE

 

Be sure to switch off the power supply at the 

wall socket and disconnect the plug before 

commencing cleaning.
•  Wait for the heater to cool down fully 

before commencing cleaning.

•  Clean the grilles of dust.
•  Only clean the body of the heater with a 

damp cloth.

•  Do not allow water into the appliance.
•  Never use soap or chemicals which may 

damage the housing of the heater.

•  Allow sufficient drying time before 

operating again.

•  When the unit is not in use, we 

recommend that it is repacked in its 

original packaging and stored in a cool, 

dry place.

DISPOSAL OF THE UNIT

Appliances bearing the symbol shown here 

may not be disposed of in domestic rubbish. 

You are required to dispose of old electrical 

and electronic appliances like this separately.

Please visit www.recycle-more.co.uk or 

www.recyclenow.co.uk 

for access to information about the recycling 

of electrical items. 

Please visit www.weeeireland.ie for access to 

information about the recycling of electrical 

items purchased in Ireland.

The WEEE directive, introduced in August 

2006, states that all electrical items must be 

recycled, rather than taken to landfill.

Please arrange to take this appliance to your 

local Civic Amenity site for recycling, once it 

has reached the end of its life.

WARNING:

 

DO NOT IMMERSE ANY ELECTRICAL PART 

OF THE APPLIANCE IN WATER SUCH AS 

MOTOR UNITS OR PLUGS.

PLEASE SEE CLEANING SECTION FOR 

FURTHER INSTRUCTIONS.

Summary of Contents for WL42009













Reviews: