16 October 2014
5
FUEL LOADS
The size of the logs and the number of pieces that can be loaded per fueling will vary with the size of the fire.
As a rule, fire wood is cut to 300 to 350mm lengths and split to 150 to 180mm cross section, depending on the wood
merchant that you purchase it from, or if you are cutting it yourself.
Generally the fuel load would be 2 to 6 pieces (depending on the size of the fire) of fuel every 25 to 40 minutes placed
in the ash pan. The fuel load will directly impact the heat output and will vary to your requirements.
GUIDE ONLY :
The amount of wood and the frequency of the wood load can be gauged by the level of embers in the ash pan along
with the height of the wood that is burning.
The ember level will build up as the fire is being used and should not exceed the level of the ash pan. Once it has filled
the ash pan and the fire is cold, remove the excess ash as described in the instructions.
The Burning wood is to be contained in the ash pan to prevent the fuel from falling out onto the hearth. If the load of
fuel is to large, or the physical size of the wood is to big, it may not fit into the ash pan, therefore the number of pieces
of wood will need to be reduced and the size will need to be cut to a smaller size.
When the ash pan is full, remove the ash, leaving 25mm in the bottom of the pan as described in the Instructions.
Note: Damage to the fire as a result of Over Firing is not covered in the Warranty.
SAFETY AND FIRE SENSE
Most firewood will spit sparks from time to time. It is strongly recommended you use a sparkguard.
NEVER
leave a
lit fire unattended.
Warmington
have a range of sparkguards, either fitted or freestanding for safety and peace of
mind.
DO NOT
overload the fire with large logs which could fall out of the fireplace and cause a fire hazard in the home.
Ensure the logs are placed at the back of the firebox and that a limit of no more than six logs be used during high fire
operation. This will vary depending on the size of the fire.
In the event of a soot or creosote fire
:
Alert all the people in the house. Have them leave or be ready to leave the house.
Call the Fire Department.
Suppress the fire the best you can being careful of your own safety.
Make sure you have a way out of the house should the fire get out of hand.
Extinguish the fire using a dry chemical household fire extinguisher, or smother it with loose soild or sand.
Putting water on the fire will turn to steam and will aid in putting out the fire—but be careful as this can spit hot
water.
GENERAL MAINTENANCE
We strongly recommend that in you have the flue swept and cleaned at least once a year to reduce the risk of a
chimney fire and ensure proper operation of the fire.
Ensure the damper is fully open when cleaning the chimney. Remove the cowl from the top of the chimney and sweep
from the top down the flue. Remove all soot and ash and ensure cowl and bird protection is cleaned and replaced.
To keep your fire clean, polish all over with a soft cloth when the unit is cool. Cleaning the Firebox interior at the end
of winter and spraying with high temperature
Stovebright
paint will extend the life of the firebox. (see General
Information paint later in this document). Ensure all surfaces are cleaned with a wire brush or scotchbrite before
applying paint.
The quality of the firewood used can have a dramatic effect on the efficiency and operation of the fire. The main
factors are moisture content, tree species and piece size. We recommend that dry timber which has been stored from
the previous year be used, and that a mix of soft and hard woods be used. A dense, hard wood will give a longer-
lasting coal bed, while a less dense wood will bring a fire to optimum temperature more quickly.
