warema_890558_alhb_en_v5•2022-02-01
We reserve the right to carry out improvements
42
Wisotronic 1-channel
Installation instructions
7.1.6 Factory reset
If you would like to make changes or correct mistakes in the Quickstart menu
after closing it with the [
Finished
] button, you can return to the beginning of
the Quickstart menu using the factory reset.
De-energize the device.
Switch the operating voltage back on.
Wait for the WAREMA logo to appear during the start routine.
Immediately hold down all four buttons on the Wisotronic briefly.
The following menu appears with the question
[
Reset to factory defaults?
]:
With the [
Yes/No
] button, confirm that you wish to reset the device to the fac-
tory settings.
The WAREMA logo appears again as well as the
[
>> setting factory defaults
] screen. The display returns to the Quick-
start menu after approx. 30 s.
The Wisotronic has now been reset to the factory settings and is ready for
reconfiguration. Follow the Quickstart menu as described in Chap. 7.1 on
page 36 ff
System settings
