890463_k•en•2019-10-01
We reserve the right to carry out improvements
2
When selecting the installation location, ensure that the
solar panel is sufficiently supplied with sunlight. For
example, an overhanging roof may shade the panel at
certain times of the day. Also avoid installing it on the
north face of buildings.
Before installing the device, consider that trees, bushes
or parts of the building may shade the photo sensor
during the course of the day. In this case, the sensor
cannot deliver exact values and the results will be
incorrect. Therefore, select the installation location
carefully.
When selecting an installation location, ensure that
the photo sensor is exposed to the same brightness
conditions as the sun shading product being
controlled. This means that you need to position the
photo diodes according to the building facades being
shaded. Ideally, the weather station is oriented in the
same direction as the sun shading product being
controlled.
Mount the device in the vicinity of the sun shading
product although not in places where the sun shading
product affects the wind currents; otherwise, the sensor
will not provide correct wind readings.
Separate spacers are included for wall and ceiling
installation. They prevent cracking and deformation of
the plastic (Fig. 2).
Fig. 2 Clipping the separate spacers into the threaded hole
Additional installation information can be found in the
documentation of your sun shading product.
Mounting plate
4,5
9,0
207,5
4,5
9,0
56
185
Fig. 3 Dimensions
Wall mounting
Fig. 4 Wall mounting
Clip one of the included spacers in the threaded hole
(horizontally or vertically, Fig. 2).
Attach the weather station to a suitable substructure
using the accompanying screws and dowels as shown
(Fig. 4).
The USB line must be correctly positioned in the guide
on the back of the mounting plate to ensure it is not
pinched during installation.
Tighten the screw on the joint.
Ceiling installation
Fig. 5 Ceiling installation
Loosen the screw on the weather station joint.
Swing the mounting plate of the weather station up by
90° (or by the necessary angle).
Tighten the screw on the joint.
Clip one of the included spacers in the threaded hole
(horizontally or vertically, Fig. 2).
Attach the weather station to a suitable substructure
using the included screws and dowels as shown (Fig. 5).
The USB line must be correctly positioned in the guide
on the back of the mounting plate to ensure it is not
pinched during installation.
Pole installation
Fig. 6 Pole installation and steel cable ties locking mechanism
