2029598_a•en•2019-10-01
We reserve the right to make technical modifications
2
Electrical connection
An on-site overload current protection device (fuse) and a
disconnecting and isolating switch to switch off the entire
system must be provided.
The unit is electrically connected according to the wiring
diagram on the reverse (Fig. 3 on page 4).
Commissioning
You can find instruction videos on our
YouTube channel
at:
http://www.youtube.com/user/SonnenLichtManager/videos
We recommend commissioning using the
PC software WMS studio pro!
Commission the WAREMA climatronic® system as
normal via the WAREMA climatronic® studio software
or manually via the climatronic® control panel.
The converter can only be put into service using WMS
studio:
Create a new project.
Add the corresponding WMS devices (sensors, receiv-
ers, transmitters) and the converter.
Adjust the settings of the individual devices.
Establish the desired connections between the WMS
devices.
Allocate the desired receivers to the converter.
Transfer the configuration to the devices.
Functions
Check status of the converter
Button/
display
Wction/result
/
Short
Press
or
briefly.
The green LED lights up for 5 s (the clima-
tronic® converter still has factory status).
Fig. 2
Using the converter in a block of flats
Connecting the AS485 side
All converters must be connected with each other via the
RS485 line and the earth line. One terminating resistor
(120 Ω) must be installed manually on each end of the
RS485 line. A valid protocol can be recognised via the
third LED on the converter.
The converter has two serial numbers, one for WMS and
one for the RS485 range.
Aestoring the factory settings
NTNCE
R
If the climatronic® converter is deleted, no fur-
ther move commands are sent to the network.
Button/
display
Wction/result
+
> 10 s
Press the
and
buttons on the cli-
matronic® converter simultaneously for at
least 10 s.
Both LEDs flash 5 times, reset and send
the delete command
