3
OPERATION INSTRUCTIONS
WAGATE SLUICE GATES – MTV, SPS-TL, SPS-TG, SPK-TG, SPM-P-TG, SPM-S-TG
SAFETY INSTRUCTIONS
This manual should be read and properly understood before product commissioning. All personnel working with the
device must be familiar with the safety and warning instructions in this document.
STANDARDS/DIRECTIVES
Our products are designed and manufactured in compliance to recognized standards and directives. This is certified in
the Declaration of Conformity.
COMMISSIONING
Before commissioning the user need to check that the product is free of any damages obtained during transport or
storage.
Prior to first use, the user needs to make sure that the steps described in the commissioning part of the manual has been
followed precisely. If the device is fitted with a third-party actuator, either supplied by the manufacturer or a third party,
the user needs to make sure that the setup and commissioning for that product is carried out following that device´s
own specific operation instructions.
Please note
that any actuator supplied by the manufacturer will not have been completely commissioned before
shipping, as the setup of electrical connection and communication interface can only be performed on site. We
recommend using a trained technician with knowledge of the chosen type of actuator for this task.
Commissioning is the sole responsibility of the user. The manufacturer cannot be held liable for any consequential
damage.
TRANSPORT AND STORAGE
TRANSPORT
The device should be kept on its original packaging during the entire transport. The shipment pallet must be kept level
and securely fastened down. It is not allowed to stack other products on top of the devise during transport.
The device can only be moved on its original shipment pallet or using at least two of the lifting points on the outside of
the device (Only applicable to sluice gates too large to be handled by hand).
Lifting the product using any other method could result in damage to personnel or the device itself.
