23
PRINTING AND REMOVING MODELS
4.5 Quick settings
To access the quick settings,press the dial button and select quick settings in the main menu
Move:
* Move X,Y,Z:
Manually move the X,Y,Z axes by 1mm increments
* Extruder:
Manually extrude or retract filament by 1mm increments
IMPORTANT NOTE:
You must preheat the extrude or retract filament,180
°C minimum
* Home XYZ:
Return to the home position is the front right corner
Change filament:
* Add filament:
On screen guide to to Add filament if no filament is currently inserted
* Remove filament:
On screen guide to remove fialment if cruuently inserted
* Preheat:
Preheat the nozzle
* Raise extruder 10mm:
Raises the extruder by 10mm
Disable steppers:
Disables all motors so you can manually move the bed and extruder position
in the X and Y directions
Preheat:
Preheat the nozzle
Cooldown:
Cools the nozzle
To access the Advanced settings,press the dail button and select advanced in the main menu.
Unless you are an experienced user we do not recommend adjusting settings in the advanced
menus.
Temperature:
* Nozzle:
Set the current temperature of the nozzle (0-250°C)
* PID-P:
Proportional Response
* PID-I:
Integral Response
* PID-D:
Derivate Response
* Preheat PLA conf:
Adjusts the default PLA heating temperature
Save setting:
Save the current settings
NOTE:
You must save settings after every changs.Unsaved settings will be lost after restar
Factory Reset:
Restores default factory settings
4.6 Advanced settings