CLEANING AND FINISHING THE PRODUCT
Wear gloves and remove the hood from the printer, loosen the building plate knob and rotate with little bit angle and let
leftover resin drop into the vat, remove as much liquid from the plate and object as possible for further prints. Use the plastic
scraper to remove the printed object safely.
Note:
Place the hood back to protect the resin from light to prevent the resin lose its properties.
16
POST PROCESSING
17
Place the platform to a washing-up bowl. Remove the objects by sliding the scraper in at their base.
Wash off any liquid polymer in alcohol container. You can gently clean it with a soft brush or sponge,
take care not to damage it, it will not achieve full hardness until after post exposing in light. An
ultrasonic cleaner will clean your objects without the possibility of damaging them.
Check your object is thoroughly clean as resin cannot be easily removed afterwards and then
leave it under water in sunlight for about 10 minutes. The longer you leave it under water the
darker the colour will get, some colour change is inevitable. When it is completely post-exposed
it will be strong and have a dry surface. Empty the contents of the vat back into the bottle by
pouring through a sieve.With the vat on a fl at surface wipe the inside thoroughly with absorbent
paper.Replace the fi lm when damaged.
WANHAO FACTORY CO.,LTD
NO.198 Gaoke Road FuYang HangZhou China
WANHAO Help Desk: 86-571-23290996
(Operating Hours: Mon-sat ; 8:00am -5:00pm)
www.wanhao3dprinter.com
Alcohol
REV.A
WANHAO DUPLICATOR 7
GETTING
STARTED
GUIDE