WangYe WY50QT-28A, Manual

Page: 2 / 20

The important points to attention
Ÿ
The driver and passenger
This motorcycle was limited to one driver and one passenger (except children younger than 12 years old).
Never exceed the Max load capacity of motorcycle.
Ÿ
For the safety, avoid driving the motorcycle in atrocious weather or cold weather (under -12
℃
).
Ÿ
For the road condition
This kinds of motorcycle can only drive on the highroad.
The caution banners about the safety or environment protection stick to the sundries box cover, the rear
carrier, and fuel tank cap. (Being visible before or during driving)
•
Please carefully read the user manual
You must attention to the warning sentence or paragraph.
WARNING
：
Not following the operation instruction in this manual may cause great damage to you.
ATTENTION
：
Not following the operation instruction in this manual may cause injury to both you and vehicle.
Regard this manual as a permanent parts, even when transfer the vehicle to a new owner, transfer the
manual at the same time.
LIST
I. Motorcycle safe drive
Rules for safe drive
…………………………
1
The payload
…………………………………
2
II. The parts &subassemblies and use
instruction
Parts & subassemblies
………………………
3
Speedometer and indicator
…………………
5
Ignition switch
………………………………
5
Fuel meter
…………………………………
6
Starting switch
……………………………
6
headlamp switch
…………………………
6
Main beam switch
…………………………
7
Turning signal light switch
…………………
7
Horn switch
…………………………………
7
Steering handle lock
…………………………
8
Seat lock
……………………………………
8
III. Operation instruction
Checking before driving
……………………
9
Engine starting
……………………………
14
Driving operation
…………………………
15
Braking operation
…………………………
16
Engine power off operation
………………
17
Stopping operation
…………
v
……………
17
IV. Service and maintenance
maintenance periodical form
………………
18
simple trouble solution
……………………
20
Cleaning air filter
…………………………
22
Maintenance battery
………………………
22
Adjusting idling speed
……………………
23
Replacing gearbox oil
………………………
24
Spark plug
…………………………………
25
Replacing Fuse
……………………………
25
V. Vehicle storage
…………………………
26
VI. Vehicle identification
…………………
27
VII. Tool set
………………………………
28
VIII. Main technique parameter
………
29
IX. Circuit diagram
………………………
31
Ⅹ
.Emission Control System
Warranty Statement
………………………
32