19
GB
Child-proof safety lock
If you turn the ignition knob to the symbol of the small flame, the remote control is put out of action
while the pilot flame will stay alight.
Arranging the height of the flames
Point the remote control handset towards the gas unit. The hearth will burn higher
when pressing the
button. The hearth will burn slower when pressing the
button.
When you keep pressing the
the hearth will switch to the pilot flame position. You
can also put the hearth on the pilot flame position manually by turning the ignition
knob (A) until the minimum is reached (small flame / PILOT).
When you press both buttons, you will see the ‘transmit’ signal top left on the display.
The hearth has reached its highest or lowest position when the LED of the receiver
starts blinking.
Switching off the pilot flame
The pilot flame is switched off manually. Remove the frame, gently press the ignition
knob (A) and then turn it towards the dot / OFF indiciation.
Lighting the hearth for the first time
When you light your gas unit for the first time, the hearth must ‘anneal’. The unit has a heat resistant lacquer
which must still burn in. Though this may give an unpleasant smell, it is otherwise harmless. It is advisable to
turn onto high for about three hours while airing the room well.
Discolouration of walls, ceilings and grates
After lighting your heath the walls, ceilings and grates may show some discolouration. This is caused
by the dust particles that burn in the convection cover. This is a natural process for which WANDERS
cannot be held responsible. To minimize the discolouring we refer to the advice given for atmospheric
hearths. Your installer can give you more information about this.
Some deposit may form on the ceramic glass of the door of the hearth. You can easily remove this deposit with
a damp cloth and if necessary some cleansing agent for ceramic rings when the glass has cooled down. On
page 26 you’ll find a description on how to remove the glass.
Avoid finger marks
Avoid leaving any finger marks on the glass after closing the door. Finger marks leave stains that burn
in the glass and cannot be removed later.
When you light your fireplace for the first time, the unit calculates how much time is needed to reach the pre-
set temperature. Your hearth will now select the most efficient way to heat the room.
Ensure that the logs are not placed in front of the pilot flame. The gas must be able to stream freely to
the main burner. The main burner is located underneath the log set. See page 28 for placing the log
set properly.
It is advisable to keep the pilot flame burning in heating seasons to prevent condensation and possible
calcification on the inside of the door.
!
!
!
!
Summary of Contents for STEALTH - SCHEMATICS
Page 61: ...61...
