44
cleaned free from soot. By removing the hob and heating plates the flue gas channel and
the flue pipe inside the stove can also be cleaned. By loosening the screw of the cleaning
cover (4) the lower part of the flue gas channel around the oven can also be cleaned.
After finishing cleaning, the heating and hob plates must be replaced correctly. The clean-
ing cover (4) under the oven needs to be closed tightly again.
PLEASE NOTE:
After every period of heating you should check the stove thoroughly. If repairs or
replacements are necessary, please contact your supplier with the necessary article
numbers and serial number in good time.
3.7.2
Varnished and enamel surfaces
Only wipe down the external surfaces when the stove is cold. Varnished surfaces should
only be washed with plain water (do not scrub). Enamel surfaces in special cases can be
cleaned with soapsuds or a bit of washing-up liquid and then wiped dry.
NOTE
:
Never use sponges, scouring products or any other chemical or abrasive
cleaning products!
3.7.3
Ceramic glass surfaces
Clean the window and/or Ceran plate before first use with a clean damp cloth. Then rub a
few drops of a ceramic glass protection product onto the glass / Ceran plate with a paper
towel.
After wiping this and polishing it dry, the high quality surface is now covered with an invisi-
ble film. The helps to keep the glass pane /Ceran plate clean and if repeated regularly,
makes it easy to clean.
3.7.4
Sheet steel
The steel sheet parts must be rubbed over with an acid-free sheet steel care product when
at
blood temperature
. Cleaning is then done when the stove is cold.
The special steel plates which radiate heat need to be taken care of regularly after each
time you cook. After any use which causes dampness or dirt to collect on the plate, you
must clean it. The hob plate should be cleaned when it is still lukewarm, which allows any
remaining water to evaporate and so prevents rust forming. Take care that you do not use
water to clean the stove when it is cold.
Expansion joints in the steel hob plate must always be cleaned free of adhesions, to avoid
deforming the steel hob plate and the side panels. If necessary the edge of the cover
should also be cleaned of any adhesions.
3.7.5
Changing the light bulb
The light bulb in the oven is exposed to high temperatures. Although it is a special kind of
bulb, it can still burn out in time. You just need to replace it with the same type of bulb
(15 W - 240 V - 300°C).
Before changing it make sure that the stove is not in use, that it is cold and that the bulb
has not been switched on. Unplug the electrical cable and check that there is no current
present. To change the bulb, remove the protective cover, change the bulb and replace the
bulb protector.
