DECALING
1. After cutting out the decal, dip in
water for 10 seconds, remove and
let stand for I minute. Slide decal
onto surface, position and then blot
off any excess water.
2. Lightly brush Micro Sol® on top.
This will soften the decal allowing it
to conform to irregular surfaces. DO
NOT TOUCH DECAL while wet!
3. When the decal is thoroughly dry,
check for any trapped air bubbles.
Prick them with the point of a small
pin or hobby knife blade and apply
more Micro Sol®.
1. Glue the walls (2, 4, 6) to the base (1).
2. Place (do not glue) the horizontal bracing (11) on the base.
3. Glue the vertical bracing (7, 8) in place on the base, making sure that
they go in front of the crosswise braces of part #11. The end most verti-
cal posts rest on top of the "lip" on the base and the remaining upright
posts go into the square holes so that they are even with the bottom of
the base.
4. Slide part #11 up and glue the bottom of the first crosswise brace on
parts # 7 and 8 and on top of the tabs on the back wall. Glue the ladders
(10) and railing (12) in place. Glue the windows (20) and window "glass"
(21) in place on clerestory wall (17) and glue this to the top and back of
part #8. Repeat for second shed.
5. Glue the clerestory end walls (16) to both the ends of both sheds
thereby, joining them into one.
6. Then, glue the clerestory braces (18) in place, one against each end
and the others in the middle, using the notches and vertical ribs on part
#8 to locate. Glue the roof pieces (14, 19) onto their respective places
to finish.
SINGLE LARGE SHED
7
8
6
4
2
1
11
21
17
20
17
17
10
10
12
19
14
16
16
18 x 10
