19
6. Preparation for operation
6.1 Connect the receiver with the studio flash and power supply
1. Switch off studio flash device.
2. Insert the sync cord in the jack of the studio flash.
3. Plug the power cord of the receiver in the jack of
the studio flash.
4. Compare the local power supply with the
connected load of the Remote Trigger.
See
Technical Specifications.
If the values should differ, please contact
[email protected] or tel. +49 8432 9489-0.
5. Connect the power cord with the socket on the
device and with the power socket.
6.2 Adjust frequency
You have the opportunity to operate the Remote
Trigger with 4 different frequencies. It is important, that
you make the same adjustments for transmitter and
receiver as in the following example.
1. Adjust the frequency on the backside of the
transmitter. Adjust the levers e.g. on 1 and 2.
2. Adjust the frequency on the backside of the
receiver. Adjust the levers e.g. on 1 and 2.
